Loading...
Behaviour of 3D printed Al7075 square hollow sections in compression
Mansour, Eman Ruan, Xionfeng Rossi, Barbara
Mansour, Eman
Ruan, Xionfeng
Rossi, Barbara
Editors
Other contributors
Affiliation
Epub Date
Issue Date
2026-01-22
Submitted date
Alternative
Abstract
High strength Aluminium alloys feature low densities, high strength‐to‐stiffness ratio, large ductility range and high fracture toughness, all attractive features for applications in industries such as automotive, aerospace and construction. To date, little attention has been given to the performance of 3D‐printed high strength Aluminium alloys such as Al7075 due to the inherent challenges in the additive manufacturing process. In this context, the present study reports material (tensile) and stub column (compression) tests on additively manufactured (AM) Al7075 square hollow sections (SHS). Both material and SHS samples were manufactured by Direct Metal Laser Sintering (DMLS), a laser powder‐bed fusion (L‐PBF) sub‐technology that uses metal powder as feedstock and a laser to fuse the feedstock layer by layer. Three newly develop set of process parameters that had successfully led to crack free medium sized samples were employed in this study. The effect of post processing treatments on the mechanical properties of printed Al7075 samples is investigated through the application of two heat treatments and a Hot Isostatics Pressing (HIP) treatment. A total of 33 material samples were manufactured and tested in tension, 6 of which in their as built condition and 27 subject to the above post processing treatments. The tensile test results showed that the Al7075 samples manufactured using the new set of parameters used is unable to produce specimens which can then develop their full tensile resistance. Nine square hollow tubes were subsequently manufactured utilising a selected heat treatment and tested in compression. All tubes successfully develop good compression performance and primarily exhibit failure due to local buckling, which led to the formation of a yield‐line‐like pattern of cracks, ultimately resulting in the specimens' failure.
Citation
Mansour, E., Ruan, X., Rossi, B., Robinson, J., Arjunan, A. & Bock, M. (2025) Behaviour of 3D printed Al7075 square hollow sections in compression. ce/papers- Proceedings in Civil Engineering, 8(6), pp. 37-42.
Publisher
Research Unit
PubMed ID
PubMed Central ID
Embedded videos
Additional Links
Type
Journal article
Language
en
Description
© 2026 The Authors. Published by SAGE. This is an open access article available under a Creative Commons licence.
The published version can be accessed at the following link on the publisher’s website: https://doi.org/10.1002/cepa.70243
Series/Report no.
ISSN
2509-7075
EISSN
2509-7075
ISBN
ISMN
Gov't Doc #
Sponsors
This research was funded by the Royal Society Research grants under agreement RSG/R2/222144 awarded to the last author. The first author is grateful to the Ministry of Higher Education of the Libyan Government for their financial contribution.